DMX MArquee W610 Especificaciones descargar pdf (Pagina 20)

Page | 20

installing video pass-thru (high definition) using the Hauppauge HD-

PVR

 Run the Component cable from the video source to the HD-PVR. Please note that the HD-

PVR supports only a component connection.

 Verify the source video using this cabling.

 Power down the digital media player.

 Place the HD-PVR in close proximity to the Marquee media player.

 Follow these instructions and refer to the figure, below, to connect the HD-PVR and W610.

a. Connect the source video to the rear panel Component Video In using the included

cable.

b. Connect the source audio to the rear panel red & white RCA-type Audio In connectors on

the bottom-left. Note: When using component video, you must utilize the audio

connectors on the rear of the HD-PVR. The optical audio in is not supported.

c. Connect the included USB cable to the connector labeled USB on the rear of the HD-PVR.

Connect the other end of the USB cable to any rear-panel USB port on the back of the

Marquee player.

 Turn power onto the video source.

 Turn power onto the displays.

 Turn power onto the Marquee media player

 Instruct the client that the component connection was used. This is critical for the client to

properly configure the Marquee software for playback.

 Should you require assistance, call DMX Customer Service at 800-345-5000.

Please see diagrams below.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Sin comentarios

DMX MArquee W610 Especificaciones Pagina 20